Precision Timing for Reliable Power.  Simplified.
9410 Meter Time Sync

  

IRIG-B Protocol Description

IRIG-B is one of a family of precision time protocols originally defined by the Inter-Range Instrumentation Group (IRIG) of the US army.   Historically, IRIG-B has been widely used by electric utilities, industrials, and others to ensure precise time synchronization of power system devices, such as breakers, relays and meters.

IRIG-B is typically distributed as a DC level shift (DCLS), pulse-width coded signal ("unmodulated IRIG-B") or as an amplitude-modulated signal based on a sine wave carrier with a frequency of 1kHz ("modulated IRIG-B").   The most common version of IRIG-B is unmodulated (5V DCLS) with full date/time, including the year, transmitted once per second.

For more details on IRIG-B protocol and its applications, see Tech Note: Overview of IRIG-B Time Code Standard (TN-102)

  

Time Sync: 9410 Power Meters

Modern industrial/commercial power systems require precise time synchronization of all devices to ensure meaningful data for analysis and reliable operation.   9410 meters from Siemens support IRIG-B (and also ASCII/RS-485) protocol for precision time sync.   CyTime™ SER-3200/2408 Sequence of Events Recorders from Cyber Sciences can generate IRIG-B to synchronize these power meters, greatly simplifying time sync design. SER-3200/2408 Event Recorders accept a variety of time source options and then sync with each other using PTP.  In turn, a PTP slave can also output a legacy protocol (e.g., IRIG-B) to devices that do not support PTP (e.g., 9410 meters).

9410 Time Sync Wiring

A 9410 Power Meter can decode an IRIG-B time sync signal via a dedicated digital input.   To take advantage of PTP (IEEE 1588) precision time sync over Ethernet, an SER-3200-PTP (or SER-2408-PTP) is configured as a time sync master with IRIG-B as its output (via PLX-5V).

9410 Setup

When using IRIG-B for time synchronization, 9410 meters are configured for time sync via a dedicated digital input.  IRIG-B can only be connected to one of the digital inputs located on the meter base, not an option module.   The device must be set as follows:

  • Clock Source = COMM
  • Time Sync Source = IRIG-B
  • Input Mode = IRIG-B (for the digital input wired to the IRIG-B signal)

For more details, see Tech Note: Overview of IRIG-B Time Code Standard (TN-102)