"I have legacy devices that use RS-485 4-wire communications, but I need to connect these to a 2-wire network. The CNV-100 from Cyber Sciences is simple—it just works!"
RS-485 2-wire to 4-wire converters reliably bridge 2-wire/4-wire devices and networks.
- Bridges 2-wire and 4-wire RS-485 devices/networks
- Operates at communication speeds of 9600, 19200, or 38400 bps
- Accepts 24 Vdc control power
- NO configuration needed!
- Standard DIN-rail mounting
- UL Listed, FCC, RoHS compliance
Instruction ManualCNV-100 Instruction Manual
No resources available.
Tech Notes (White Papers)Tech Note: RS485 2wire/4wire
RS-485 Connectivity (CNV-100)
Ensure connectivity of RS-485 devices! The CNV-100 enables interoperability of RS485 2-wire and 4-wire multi-point data communication networks. The CNV-100 connects 2-wire devices to 4-wire systems or 4-wire devices to 2-wire systems. LEDs flash to confirm data transmit/receive at both 2-wire and 4-wire sides.
The CNV-100 RS-485 (EIA-485) interfaces conform to the Modbus standard for RS-485 serial data communications. In general, it can be used with any protocol that adheres to the RS-485 standard operating at baud rates of 9600, 19.2k or 38.4k bps.
Reliable operation. The RS-485 2-Wire to 4-Wire Converter uses proven technology. Thousands of devices have been in operation since its introduction in 2003.
The RS-485 2-Wire to 4-Wire Converter operates automatically for any supported baud rates. No setup required. No DIP switches to set!
Available now—IN STOCK! The RS-485 2-Wire to 4-Wire Converter is stocked in quantity in our factory and is available for immediate shipment.
|CNV-100||RS-485 2-wire to 4-wire Converter (CNV-100)|
Markets & Applicatioins
“Microgrids combining utility sources, wind and solar power are complex by design. The requirement for SER with 1 ms accuracy is a given."
“I thought we could get by with basic metering and NTP time sync, but then we had an incident. The CyTime SER-3200 gave us the data to reconstruct why our transfer scheme switched over to generator power. Now I specify all SER devices with 1ms accuracy.“